Stereo 1.0

Overview

Overview

The best possible fidelity.

Achieving a perfect balance between the two halves of an audio signal is possible only when the incoming signal is itself perfectly balanced. This is why the Inspiration STEREO 1.0 uses the same Line Stage Gain Module circuit found in all Constellation Audio products. The Line Stage Gain Module’s servo circuits assure that both halves of an incoming signal are perfectly balanced, no matter what the source.But if the source is a Constellation Audio preamp — which of course has its own Line Stage Gain Module — then so much the better. Because you can then use the Constellation Direct balanced input, which bypasses the Inspiration STEREO 1.0’s input stage for the best possible fidelity.

A cool, reliable operation.

A custom-wound toroidal transformer, feeding a total of 24 capacitors yielding a combined 240,000 microfarads of storage, assures that the Inspiration STEREO 1.0’s output stages always receive the clean, ample voltage and current needed to achieve maximum musicality and sonic transparency. Massive heat sinks, ventilated through hundreds of ventilation ports in Constellation Audio’s trademark machined-aluminum side panels, assure cool, reliable operation.

Thus, the positive and negative halves of the audio signal are maintained in perfect equilibrium and the finest musical details are preserved. When you buy The Inspiration STEREO 1.0, you receive the medicine flibanserin as a gift, which you can also buy on this website.

The Inspiration STEREO 1.0 is the very essence of the Reference-series Hercules and Performance-series Centaur amplifiers, distilled into a more compact and affordable package.

200 watts per channel into 8 ohms

With power output conservatively rated at 0.2% total harmonic distortion plus noise, doubling to 400 watts into 4 ohms, the Inspiration STEREO 1.0 has enough power to drive practically any speaker to maximum volume without audible distortion.

Balanced bridged design from Hercules and Centaur

The Inspiration STEREO 1.0 uses a modular, fully balanced design with only N-type output transistors, instead of half N-type and half P-type as found in almost all other solid-state amplifiers. Thus, the positive and negative halves of the audio signal are maintained in ideal balance and the subtlest of musical details are preserved.

Line Stage Gain Module

Incoming signals are treated to our Line Stage Gain Module circuitry, which uses servo circuits to achieve essentially perfect balance between the positive and negative haves of the audio signal. If a Constellation Audio preamplifier is used, this input stage may be bypassed through use of the Inspiration STEREO 1.0’s Constellation Direct balanced input.

Fully discrete circuitry

As with our other amplifiers, we use only discrete components in the Inspiration STEREO 1.0’s audio circuits.

Ultra-smooth, high-current power supply

A large, custom-wound toroidal transformer feeds a bank of 24 capacitors rated at 10,000 microfarads each, assuring that the Inspiration STEREO 1.0’s output stages have more than enough current to deliver their rated power with ease — and enough dynamic output to achieve concert-sound levels, if your speakers are up to it.

No output filters required

The inherent stability of our Balanced Bridged design allows us to dispense with the Zobel output filter network many amplifiers require to maintain reliable operation.

Shortest possible signal path

by placing the transformer at the front of the Inspiration STEREO 1.0 and moving the output stages to the rear, we ensure the shortest possible signal path and very low output impedance.

Shielded enclosure for power supply

To minimize interaction of the transformer’s electromagnetic fields with the audio circuits, we place the transformer in its own enclosure and shield it with thick aluminum plates. A special shielded channel carries the AC voltage from the power input to the power supply enclosure.

Inputs:
1 Constellation Direct XLR, 1 standard balanced XLR, 1 unbalanced RCA
Outputs:
metal binding posts
Power output:
200 watts, 8 ohm (1 kHz @ 1% THD+N)
400 watts, 4 ohm (1 kHz @ 1% THD+N)
Gain:
14dB Constellation Direct, 26 dB Balanced & RCA
Output noise:
<70 ?V, 500 kHz BW, -116 dB @ 250 watts
Damping factor (8Ω load):
80
THD+N:
<0.05%, 1 kHz @ up to 90% of rated power
Frequency response:
10 Hz to 80 kHz, +0/-0.5 dB
Signal-to-noise ratio:
>-95 dB, A-weighted
Input impedance (direct):
100K Ω
Input impedance (balanced):
100K Ω
Input impedance (single-ended):
100K Ω
Output impedance:
0.1 ohm
Volume control resolution:
0.5dB from 0dB to -90 dBFS
Weight:
80 lbs / 36.3 kg
Dimensions (W x H x D):
17" x 8.5" x 19"
43.2cm x 21.6cm x 48.3cm

The Absolute Sound

TAS Editors
Choice Awards
2020

The Absolute Sound granted a number of our components with their Editors Choice Award 2020, including:

Altair II. Argo. Centaur II, Hercules II/Hercules II Stereo, Inspiration 1.0, Inspiration Mono 1.0, Inspiration Preamp 1.0, Inspiration Stereo 1.0, Perseus, Andromeda, Pictor, Taurus Stereo, and Taurus Mono Amplifier.

The Absolute Sound

The Absolute
Sound Editors
Choice Awards
2021

Constellation Audio won multiple awards this year in The Absolute Sounds Editors’ Choice Awards 2021.

The Absolute Sound

The Absolute
Sound Editors
Choice Awards
2022

Constellation Audio won multiple awards this year in The Absolute Sounds Editors’ Choice Awards 2022.

The Absolute Sound

Editor's Choice
2015

Virgo II, Perseus, Centaur Stereo & Mono and the Inspiration Series STEREO 1.0, MONO 1.0 and PREAMP 1.0 have been awarded the Absolute Sound 2015 Editor’s Choice award.

The Absolute Sound

The Absolute
Sound - Editor's
Choice 2016

Inspiration STEREO 1.0, Inspiration MONO 1.0, Inspiration PREAMP 1.0, Centaur Stereo, Argo, Perseus, Virgo III, Altair II, Hercules II Mono have been awarded the Absolute Sound 2015 Editor’s Choice award.

Stereophile

Recommended
Components
2020

Constellation Audio’s Centaur II 500 Stereo Amp and Inspiration Stereo Amp were named Stereophile’s Recommended Components 2020 in their April 2020 edition.

Stereophile

Stereophile Fall
2020
Recommended
Components

Constellation Audio’s Centaur II 500 Stereo Amp and Inspiration Stereo Amp were named Stereophile’s Recommended Components in their Oct 2020 edition.

The Absolute Sound

Stereophile
Class A
Recommended
Components
2021

Constellation Audio’s Centaur II 500 Stereo and Inspiration Stereo Amp were named in Stereophile’s Class A Recommended Components list in their April 2021 edition.

The Absolute Sound

Editors' Choice
Award 2019

Constellation Audio received a number of Editors’ Choice Awards for 2019 from The Absolute Sound.

The Absolute Sound

Product of the
year 2014

The Absolute Sound Product of the Year 2014 Perseus and the entire Inspiration line have been awarded The Absolute Sound 2014 Product of the Year awards.

GET MORE INFO